Tweco 9-8311 Manuel d'utilisateur télécharger pdf

October 7, 2010 1 Manual 0-5121 Rev. AA

Scope

This kit is for use only with the following Thermal Dy-

namics Plasma Cutting Systems:

Do not use this kit with any other equipment.

CutMaster 52,82,102,152

CutMaster 12mm,20mm,25mm,35mm, 40mm

CutMaster A40, A60,A80,A120

Supplied Parts

The kits include:

• Automation Interface Pcb 9-8388

• Wire Harness

• (2) #6-32x3/8 Pan Head Screws

• (2) M4x10mm Torx Head Screws

• Installation Instructions

Instructions

WARNINGS

Disconnect primary power at the source before

performing any inspection or repairs.

Only a qualiﬁ ed technician should perform this

procedure.

Follow the electrostatic discharge instructions

included with the component to prevent damage

to the component.

Manual 0-5121

Automation Interface Kit No. 9-8311

For CutMaster True Series

Installation Instructions

Installation Procedure

1. Remove the power supply cover.

2. Connect the supplied harness to the Automation

Interface Pcb by attaching the Fast-on terminal onto

the mating male terminal and the 8 socket receptacle

onto the P2 connector.

3. Remove the lower hole plug from the rear panel.

1 2 3

Résumé du contenu

Page 1 - For CutMaster True Series

October 7, 2010 1 Manual 0-5121 Rev. AA ScopeThis kit is for use only with the following Thermal Dy-namics Plasma Cutting Systems: Do not use

Page 2

October 7, 2010 2 Manual 0-5121 Rev. AA 4. Using the two (2) #6-32x3/8 Pan Head Screws, mount the pcb onto the rear panel, oriented as shown

Page 3 - Art # A-09819

October 7, 2010 3 Manual 0-5121 Rev. AA +12VDCPCB4AUTOMATIONINTERFACE PCB}OK-TO-MOVE FULL FEATURED AUTOMATION INTERFACE PCB OPTION(+)}To conf

Commentaires sur ces manuels

Pas de commentaire

Tweco 9-8311 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Tweco 9-8311. Tweco 9-8311 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Tweco 9-8311